Publicité
Les langues disponibles
Les langues disponibles
WARNING
NOTE
This tool is lubricated before it leaves the factory. This lubrication should
last for the life of the tool. No further lubrication is required.
REPLACING BRUSHES
1.
Unscrew the cap of external changeable carbon brushes (2).
2.
Remove the carbon brush from the brush holder.
3.
Insert a new carbon brush.
4.
Re-fasten the cap.
5.
Before using, run tool for a few minutes to allow the carbon brushes to adjust.
CLEANING
With the motor running, blow dirt and dust out of all air vents with dry air at least once
a week. Wear safety glasses when performing this. Exterior plastic parts may be
cleaned a damp cloth and mild detergent. Although these parts are highly are solvent
resistant, NEVER use solvent.
Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may become hazardous when used on
another tool.
Recommended accessories for use with your tool are available at extra cost from your
local service center.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustments should be performed by certified service centers or other qualified
service organizations, always using identical replacement parts.
Before disposing of damaged, check with your state Environmental Protection Agency
to find out about special restrictions on the disposal of tool or return them to a certified
service center for recycling.
ACDelco, ACDelco Emblem and the ACDelco related graphics are General Motors
Trademarks used under license to Mobiletron Electronics Co., Ltd.
1English1
MAINTENANCE
Remove the battery pack from this tool before cleaning solutions.
ACCESSORIES
PROTECTING THE ENVIRONMENT
English
-12
Publicité
