Publicité
Les langues disponibles
Les langues disponibles
NOTE
Always check the direction of the rotation before use. Do not change direction
while the tool is doing the work.
APPLYING WAX TO A WORK SURFACE
1. Attached the foam compounding pad on the sanding pad.
2. Apply wax to the pad. Do not apply wax directly to the work surface.
a. Liquid wax: Apply two swirls of wax over the wax applicator pad. Apply more
wax to the pad as needed to finish waxing the work surface. The pad will not
absorb as much wax when reloading.
b. Paste wax: Use a putty knife or flat object to spread about a heaping teaspoonful
of wax evenly over the surface of the wax applicator pad.
NOTE
Due to its heavier consistency, using paste wax requires the 12V battery pack to
work harder when applying and removing the wax. This will shorten the run
time of the battery. For optimal battery performance, liquid wax is preferable.
3. Place the tool on the work surface and press the switch.
a. Use across-the-board strokes in a crisscross pattern on large flat surfaces.
b. Do not press down on the tool while using. The weight and rotation of the tool
make the work go well.
c. Do not operate the tool when it is not on a work surface.
1English1
OPERATION
English
-9
Publicité
