Husqvarna 230iB Manuel D'utilisation page 11

To start the product
1. Push and hold the power button (A) until the green
LED light (B) comes on.
B
2. Use the power trigger to control the speed.
To stop the product
1. Release the power trigger.
2. Push and hold the power button until the green LED
light comes off.
3. Remove the battery from the product. Push the two
release buttons and pull out the battery.
To set the optimal airflow for your work
1. Push the power trigger and hold it at the optimal
airflow for your work.
1516 - 002 - 22.07.2020
2. Push the cruise control button to set the selected
airflow. The LED comes on.
A
3. Continue to operate the product without the power
trigger pushed.
4. Push the cruise control button again to stop the
cruise control function.
To temporarily increase the airflow
1. Start the product. Refer to
page 11 .
2. Push the power boost button to get the maximum
airflow. The LED comes on.
3. Release the power boost button to use the product
with the initial air flow.
To start the product on
11