Baumer OADM 20I6 Série Manuel D'utilisation page 49

Time Description of timing functions
Minimum button hold time to enter
t1
teach mode
Maximum waiting time after teaching
t2
the first position.
LED on as response for the first
t3
position.
Maximum waiting time after teaching
t4 the second position.
LED Blinking for "NOT OK response"
t6
after teaching the second position.
Minimal time between high/low
transition of alarm output high/low
t7
transition of the external teach input
at the beginning of the teach.
Pulse lengths on external teach input
t8
for first position.
Pulse lengths on external teach input
t9
for second position.
Delays between teach signal and
t10 response on alarm output at the
rising edge of the signal.
Delay between teach signal and
t11 response on alarm output at the
falling edge of the signal
Minimum blinking time for the reset
t12
to factory settings with button.
Blinking time after reset to factory
t13
settings
Minimum blinking time for the reset
t14 to factory settings with external
teach input.
Minimum high time of the external
teach input after the alarm output
t15
has been set at the end of the
setting of the factory settings.
BA_OADM20I6_21I6_most.doc
12.06.2017
Value Comment
Using the button, this feature can only be used
within 5 minutes after power-up. Using the
5 s
external teach input, it may be used at any
time.
If the button has not been pushed during this
< 20 s interval, the sensor will leave the teach mode
without any changes.
approx 3 s
If the button has not been pushed during this
< 20 s interval, the sensor will leave the teach mode
without any changes.
approx 5 s
1 ms
30..2000 ms
30..2000 ms
< 20 ms
< 10 ms
10 s
As long as the button is down or the external
> 0.2 s
teach input is high.
10 s
0.2 s
49/87 Baumer
Frauenfeld, Switzerland