Classic Accessories Oswego Manuel De L'utilisateur page 12

O S W E G O P O N T O O N B O A T O W N E R ' S M A N U A L
5. Attach the seat to the seat frame.
Locate the four 2 inch (5 cm) screws coming out of the bottom
of the seat. Unscrew the wing nuts and remove the washers and
lock washers. Place the seat with screws facing downwards into
the two bars on the seat frame and position the seat in the place
that is best for your height and weight (see above). Once the
seat placement has been determined, attach the washers, lock
washers and wing nuts onto the screws and tighten to hold the
seat into place.
6. Attach the seat frame to the pontoon frames.
Insert the seat platform tubes onto the pontoon frame
posts with the seat facing the front. The front of the
pontoon frames are the ends labeled "L" (left) and "R"
(right). (You may need to LIGHTLY tap the frames with a
rubber mallet to fit).
Align the holes and secure with four clevis pins.
You MUST lock the security retainers on all four clevis
pins to insure that the frame stays together.
Insert clevis pins on the frame side not in between
bladder and frame to avoid abrasion of pontoon.
7. Attach the rear platform frame.
In order to attach the rear platform frame you must first
partially attach the wire cargo deck. Start by sliding the
bent wire tabs into the slots welded on to the rear of each
pontoon frame.
Next, push the rear platform frame tubes into the open
tubes on the rear of each pontoon frame. Make sure to
insert the wire guides on the rear of the wire cargo deck
into the corresponding holes on the rear platform frame as
you push the tubes together.
Attach the rear corners with two clevis pins. These secure
the wire cargo deck and the rear platform frame to the
pontoon.
8. Thread the anchor bag cord.
Start by feeding the cord into the front
anchor cord pulley located on the side
of either pontoon frame. Continue by
threading the cord through the cord
guides and under all frame tubes.
Next, insert the cord through the rear
cord tube guide [1] on the rear platform
frame. Finish by threading the cord
through the pulley mounted on the rear
platform frame and attaching the cord to
the anchor bag.
Note: Seat and p0ntoons
removed for clarity
1
Attach this
end of anchor
line to the
anchor bag
Front anchor
cord pulley
12
Motor mount can
be mounted to
either side
Note: The anchor bracket can be placed
on either side of the rear platform frame.
Insert the included ball-end wrench into
the bottom of the anchor stud while
holding the nut on top of the stud with
an adjustable wrench
to loosen.