Table des Matières
Publicité
Connector identification at the control unit:
1
31 / 30 / 15
2
Receiver
4
SAT IN
antenna
5
SAT OUT
AUX-Relais
6
1
Rear of the vehicle
2
Driving direction
3
Elbow connector
4
External unit
5
Assembly plate
6
Length 4.5 m from external unit
9
fuse fixing
10
Vision III Control unit für Oyster® / Control Unit for CARO®+ and Cosmo®
11
Coax cable Length 1.5 m from control unit
12
Cable (black)
Premium TV with integrated Receiver
13
14
Cable (brown - minus pole)
15
Cable (red - plus pole)
16
On-board battery
Ignition Pin 15
17
Connect here the provided power cable.
ATTENTION!
Make sure beforehand that the power cable is correctly connected to electricity mains of the
vehicle at the other end; in case of wrong polarity the control unit can be destroyed!
Connect here the white 4 pin plug (CARO®+ and Cosmo® 12 pin) of the provided control cable
to the external unit. (Control cable and coax cable to the external unit are together in a black
sheath.)
Connect here the antenna plug (F plug) of the provided control cable to the external unit. (Con-
trol cable and coax cable to the external unit are together in a black sheath.)
Connect this socket with the input socket of your satellite receiver using the included shorter
coax cable.
Without function, don't use for „Oyster® TV" devices.
29
Publicité
Table des Matières
