Cameo XNODE 4 Manuel D'utilisation page 18

SCREEN SAVER
Under Screen Saver, a selection list is presented to you with the following options:
 Enable: Screen saver is enabled.
 Disable: Screen saver is disabled.
A bullet point is shown next to the currently active setting. Use the encoder wheel to select the desired setting and push [OK] to apply the
setting.
Please refer to the section Screen Saver on page 24 for more details about the behaviour of the screen saver.
MUTE LEDS
Under Mute LEDs, a selection list is presented to you with the following options:
• Mute: All status indicator LEDs of the device remain dark regardless of the device's status.
• Unmute: The status indicator LEDs behave as described under Status LEDs on page 23.
A bullet point is shown next to the currently active setting. Use the encoder wheel to select the desired setting and push [OK] in order to
apply the setting.
All previously listed device settings can be changed via the web interface on the
Device Settings Page as described on page 26.
USER INPUT LOCKING
The menu item User Input Locking allows you to lock your device with a password to protect your device from unauthorized or accidental
manipulation. Alternatively, the device may also be locked without a password in order to just prevent accidental manipulation. For details
see Simple Locking on page 19.
When the device is locked, the user will only be able to see the Home Screen (see page 8) and the Ethernet Port Status Information. Since
the menu is unavailable while the device is locked, the Ethernet Port Status Information is only accessible via the Ethernet port button [E].
When pressing the [OK] button from the Home Screen of a locked device, it will prompt for the password if the device was password locked.
If the password is then entered correctly, the device becomes unlocked and the main menu is displayed.
Otherwise, if simple locking was used, a dialog will be shown asking the user to press [Cancel] three times within 3 seconds after pressing
[OK] while the Home Screen is shown, and the device was locked. If the user does so, the device becomes unlocked.
A padlock symbol in the top right corner of the Home Screen indicates that the user input is currently locked.
Before a device can be locked by password, a password must be set, and locking must be enabled.
SET PASSWORD
Choose the menu entry Settings > User Input Locking > Set Password to set a password. A dialog will show up that prompts for a password.
Password editing works just like editing the device name.
Once the password has been entered, XNODE 4 will ask you to enter the password a second time.
18