Memory Problems; Usb Device Problems; Power Failures - Fujitsu STYLISTIC Q702 Guide D'utilisation

Problem
Tablet is not responding to
the pen

Memory Problems

Your System screen in the
Control Panel doesn't show
correct amount of memory.

USB Device Problems

Your system doesn't recog-
nize a USB device you
installed, or the device
doesn't work properly.

Power Failures

You turn on your Hybrid Tab-
let and nothing seems to
happen.
Possible Cause
System may have crashed.
You have a memory failure.
The device is not properly
installed.
The device may have been
installed while an application
was running, so your system is
not aware of its installation.
Your device may not have the
correct software driver active.
The installed battery is com-
pletely discharged or there is no
power adapter installed.
The battery is installed but is
faulty or very low.
System is at a critical thermal
limit.
Possible Solutions
If the Hybrid Tablet does not respond to the pen, connect an external keyboard to the
system to see if it responds to keyboard commands. If the system doesn't respond to
a keyboard, the application or system may have crashed, and it may be necessary to
reboot the system. If the system responds to a keyboard but not to a pen, contact
your local help desk or reseller, or call Fujitsu Service and Support at 1-800-8Fujitsu
(1-800-838-5487) for further assistance.
Check for Power On Self Test (POST) messages.
page 60.
Remove and re-install the device.
Close the application and restart your Hybrid Tablet.
See your software documentation and activate the correct driver.
Check the Status Indicator Panel to determine the presence and condition of the bat-
tery. See "Status Indicator Panel" on page 20. Install a charged battery or a Power
adapter.
When the battery reaches a critically low level, the system is forced into Sleep mode
to avoid a total system power failure. To correct this problem, either connect an exter-
nal power supply (such as the AC adapter), or install a charged battery in the tablet.
To avoid damage to heat-sensitive components, the system enters sleep mode when
it gets too hot. System operation cannot be resumed until the Hybrid Tablet cools off
to a tolerable temperature. Move the Hybrid Tablet to a cooler location.
56 - Troubleshooting
See "Power On Self Test Messages" on