Problem; Pen Input Problems; Memory Problems; Usb Device Problems - Fujitsu STYLISTIC Q552 Guide D'utilisation

Problem

You have installed an optional
external keyboard or mouse, and
it does not seem to work.
(continued)
You connected an external key-
board or a mouse and it seems
to be locking up the system.

Pen Input Problems

Cursor is not tracking the pen.
Tablet is not responding to the
pen

Memory Problems

Your System screen in the Control
Panel does not show the correct
amount of installed memory.

USB Device Problems

Your system doesn't recognize a
USB device you installed, or the
device doesn't work properly.
Possible Cause
Your operating system is not set up
with correct software driver for that
device.
Your operating system is not setup
with correct driver.
Your system has crashed.
Display needs to be calibrated
System may have crashed.
You have a memory failure.
The device is not properly installed.
Your device may not have the correct
software driver active.
55 - Troubleshooting
Possible Solutions
Check your device and operating system documentation and activate the
proper driver.
Check your device and operating system documentation and activate the
proper driver.
Try to restart your Tablet PC.
See "Calibrating the Display" on page 25. for more information.
If the Tablet PC does not respond to the pen, connect an external keyboard
to the system to see if it responds to keyboard commands. If the system
doesn't respond to a keyboard, the application or system may have
crashed, and it may be necessary to reboot the system. If the system
responds to a keyboard but not to a pen, contact your local help desk or
reseller, or call Fujitsu Service and Support at 1-800-8FUJITSU (1-800-838-
5487) for further assistance.
Check for Power On Self Test (POST) messages. See "Power On Self Test
Messages" on page 60.
Remove and re-install the device.
See your software documentation and activate the correct driver.