Greencut GLM770XE Manuel D'utilisation page 88

88
ADJUSTMENTS
ADJUSTING THE HANDLE
The handlebar must be adjusted to the height of the work to be carried out.
Loosen the locking levers, adjust the handlebar to the required height and then
re-adjust the levers to close them, making sure that the toothed wheels of the
locking system are properly seated between them.
ATTENTION: For more safety, the height adjustment of the
handlebar is limited by a locking system. Do not attempt to
adjust the handlebar to a height where the toothed wheels
are not engaged with each other.
ADJUSTING CUTTING HEIGHT
This mechanism raises/lowers the mower deck and has several steps. When setting cutting height, keep in mind that
weeds can spread more easily in very short grass. If the grass is long, it may be necessary to cut it in several passes,
lowering the cutting height little by little. To set the cutting height:
1. Pull the height adjustment lever outward so that it disengages with the teeth.
2. Move the lever forward to raise, or backward to lower the cutting height.
3. Release it at the desired height.
USE
When the engine is idling (slowest continuous running speed), the cutting action is minimal. As the engine speed
increases, the cutting action becomes more efficient. Operate the engine at a sufficient speed to provide the desired
cutting action. This may vary depending on the type of grass, grass height and density, etc.
THROTTLE
Manual throttles motors usually have a choke setting on the throttle that is used to start the engine when it is cold.
Once the engine is started, the machine can be used. For manual throttle machines, you adjust the engine speed
manually. For example, when cutting thicker or longer grass, increase the engine speed.
The position of this lever determines the motor speed. To decrease the motor speed, slide the lever upwards. On the
other hand, if you want to increase the motor speed you must slide the lever down, but not to the end.
When you are pushing the mower from one area to another, but not cutting, you can "idle" the engine (run it slow,
but not stop). Place the throttle lever upwards.
1.
3.
2.