Bre 14-3 125 - Flex BME 14-3 L Notice D'instruction D'origine

Machining flat areas:
Hold electric power tool with both hands.

To give the surface a decorative finish:
Carefully place the electric power tool on

the area to be machined and move the
power tool forwards and backwards in
a linear motion.
Connecting an extraction system
NOTE
It is recommended to use a FLEX Class M
dust extractor.
Attach extraction hose to the connector on

the guard hood.
Attach power cord to the extraction hose

using the enclosed cable holders (3x).
Connect extraction hose to the dust

extraction system. Follow the operating
instructions for the dust extraction system!
Check the attachment! If required, use an
appropriate adapter.
NOTE
If your dust extractor requires a special
connection (i.e. a connection other than the
32 mm/36 mm standard connection which is
included with the electric power tool),
contact your dust extractor supplier to
obtain the appropriate adapter.
24
Belt sander attachment

BRE 14-3 125

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Attaching or changing the sanding belt
CAUTION!
Observe the specified running direction of
the belt! Running direction must correspond
with the arrow on the gear head.
Pull out the mains plug.

Press the swing arm towards the rubber

drive roller and hold down
Place the sanding belt over the rollers.

Release the swing arm.

Check that the belt is situated fully on the

rollers.
Adjusting the handle
When working in areas which are difficult to
access, e.g. handrails attached to walls, the
handle can be attached to the other side of
the swing arm.
TRINOXFLEX