Flex BME 14-3 L Notice D'instruction D'origine page 23

TRINOXFLEX
Open the locking ring for fastening the cover.

Attach the protective cover (1.).

Close the closing ring for fastening the

cover (2.).
Screw in the securing bolt (3.).

Attaching tool
The tool holder enables the tool to be
changed without any tools.
Pull out the mains plug.

Press and hold down the spindle lock (1.).

Push tool or tool support onto the tool

holder (tongue and groove form fit) (2.).
Press the tool downwards against the

spring pressure (3.) and turn clockwise (4.).
The tool holder is locked.
NOTE
The tool holder has a width of 100 mm.
Depending on the tool width, several tools
must be attached or differences in width
must be equalised with the spacer rings.
Example:
Polishing wheel 50 mm wide: .......2 tools
–
Wire brush 70 mm wide: ......spacer rings
–
Buffing wheel 10 mm wide: ....................
–
.......................... 8 tools and spacer rings
Insert the mains plug into the socket.

Switch on the electric power tool (without

locking the button) and leave it running for
approx. 30 seconds. Check for imbalances
and vibrations.
Switch off the electric power tool.

Using the parallel guide
The parallel guide ensures exact straight
running when machining profiles.
Loosen the locking screw on the parallel

guide (1.).
Adjust the parallel guide (2.).

Re-tighten the locking screw.

Working with the rubber air roller
The rubber air roller is particularly suitable
for sanding contours, as it can be adjusted
to the surface shape of the workpiece.
Push sanding sleeves over the uninflated

rubber air roller.
Remove valve cap. Inflate the rubber air

roller using the air pump.
To release the air at the back of the valve

cap, open the valve.
NOTE
If the grain of the sanding sleeve has to be
changed very frequently, we recommend
using a second rubber air roll from the
accessories range.
Work instructions for the burnishing
attachment
CAUTION!
When the appliance is switched off, the
grinding tool continues running briefly.
23