Publicité
Les langues disponibles
Les langues disponibles
TO REMOVE THE SIDE GRILLES
In some models, the side accessory holder grilles are equipped with fixing screws (Fig. 3) for optimum
stability.
1.
Remove the screws and relative plates on the right and left with the aid of a coin or tool (Fig. 4).
2.
To remove the grilles, lift the up (1) and turn them (2) as shown in Fig. 5.
Fig. 3
Fig. 4
MOVING THE TOP HEATING ELEMENT (SOME MODELS ONLY)
1.
Remove the side accessory holder grilles.
2.
Pull the heating element out a little (Fig. 6) and lower it (Fig. 7).
3.
To reposition the heating element, lift it up, pulling it slightly towards you, making sure it comes to
rest on the lateral supports.
Fig. 6
Fig. 7
REPLACING THE OVEN LAMP
To replace the rear lamp (if present):
1.
Disconnect the oven from the power supply.
2.
Unscrew the lamp cover (Fig. 8), replace the lamp (see note for lamp type) and screw the lamp cover
back on.
3.
Reconnect the oven to the power supply.
To replace the side lamp (if present):
1.
Disconnect the oven from the power supply.
2.
Remove the side accessory holder grilles, if present.
3.
Use a screwdriver to prise off the lamp cover.
4.
Replace the lamp (see note for lamp type).
5.
Refit the lamp cover, pushing it on firmly until it clicks into place.
6.
Refit the side accessory holder grilles.
7.
Reconnect the oven to the power supply.
Fig. 8
Fig. 9
N.B:
-
Only use 25-40W/230V type E-14, T300°C incandescent lamps, or 20-40W/230 V type G9, T300°C
halogen lamps.
-
Lamps are available from our After-sales Service.
IMPORTANT:
-
If using halogen lamps, do not handle with bare hands since fingerprints can damage them.
-
Do not use the oven until the lamp cover has been repositioned.
Fig. 5
Fig. 10
Fig. 11
GB26
Publicité
