Care And Cleaning - Sharp SJ-EX820P Mode D'emploi

Care and cleaning

Important
To prevent cracks on inside surfaces and plastic
components, follow these tips.
• Wipe out food oil adhered to plastic parts.
• Some household chemicals may cause damage, so use
only diluted washing-up liquid (soapy water).
• If undiluted detergent is used or soapy water is not
wiped off thoroughly, it may result in cracks of plastic
parts.
Cleaning
■ Remove the accessories (e.g. shelves) from the cabinet
and the door. Wash them by warm soapy dishwashing
water. After that, rinse them in clean water and dry.
(Only fruit and vegetable shelf is not removable.)
■ Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off
soapy water thoroughly.
■ Wipe the exterior with a soft cloth each time it gets
dirty.
■ Clean the Magnetic door seal with a toothbrush and
warm soapy dishwashing water.
■ Wipe the control panel with a dry cloth.
Note
• Do not use heavy-duty cleansers or solvents (lacquer,
paint, polishing powder, benzine, boiled water, etc.)
which may cause damages.
• If you pull out the power plug once, wait 5 minutes at
least before connecting the power plug again.
• The glass shelves weigh approximately 3 kg each. Hold
them firmly when remove from the cabinet and carry.
• Do not drop objects inside the refrigerator or strike the
inner wall. This may cause cracks to inner surface.
Tips for saving energy
■ Keep the ventilation space as much as
possible around the refrigerator.
■ Keep your refrigerator out of direct sunlight,
and do not place it next to heat generating
appliance.
■ Avoid opening the door as much as possible.
■ Hot foods should be cooled before storing.
■ Place the food evenly on the shelves to allow
the cool air to circulate efficiently.
Before transporting
Wipe up water in the evaporating pan. Before wiping
up the water, wait more than 1 hour after pulling out the
power plug because refrigeration cycle equipment is
extremely hot.
(The evaporating pan is located on the rear of the
product.)
Switching off your refrigerator
If the refrigerator needs to be switched off for an
extended period, the following steps should be taken to
reduce the growth of mold:
1. Remove all food.
2. Remove the power plug from the socket.
3. Clean and dry the interior thoroughly.
4. Keep all the doors open slightly for a few days to dry.
Defrosting
Defrosting is automatically operated by a unique energy
saving system.
When the compartment light is blown
Contact the service agent approved by SHARP to
replace the light. The light is not to be replaced other
than by qualified service personnel.
Power consumption
Power consumption of this model is measured according to the
international standard of refrigerator performance.
If the refrigerator is operated with the
accessories (shaded area) taken out,
it works under the most energy efficient
condition.
• The amount of power consumption
of this model is measured with these
accessories taken out as indicated
shaded area.
• The amount of power
consumption of this model
is measured under the
space dimensions on the
right picture.
Evaporating pan
60mm
90mm
300mm 300mm
13