Assembly - Greencut MOTOAZADA GTC180X Manuel D'utilisation

ASSEMBLY

SPUR INSTALLATION
Insert the spur leaving it at the correct height and insert the bolt (B) fixing it with the key (A).
MOUNTING THE TRANSPORT WHEEL
• Position the transport wheel as shown in the figure, securing it with the screw and nut.
• There are two positions to be set on the transport wheel. When transporting or storing the hoe, set the wheel to
position (B). When working the soil, move the transport wheel to position (A).
HANDLEBAR MOUNTING
• Position the lower handlebar bar and tighten the 4 screws with their washers.
• Fit the upper handlebars using the screws with their washers.
FILL THE ENGINE CRANKCASE
NOTE: The engine comes without oil. Oil must be added before starting the engine.
1. Add the oil. Do not overfill. Use clean oils and high quality detergent. Do not mix oil with gasoline. The oil level
must be full. Check the oil level by removing the filler cap.
2. Always check the oil level before starting the engine. Refer to the "technical characteristics" section for the
capacity and type of oil to be used.
A
B
A
B
55
EN