Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
JET whirl system
The JET whirl system is a water/air circulating system.
The status display (LED – light-emitting diode) above the function key «JET»
flashes for 0.5 seconds every second when the controller is connected to the
mains (= mains voltage present).
Important
Never operate the JET whirl system without water! The pump could
suffer permanent damage if run dry for only a few minutes.
Only switch the JET whirl system on when the water level is 5 cm above
the neck jet.
The JET whirl system is switched off automatically after 20 minutes. The
automatic cut-out is a safety function against accidental operation of the
whirl system.
Press once
Whirlsystem auf Dauerbetrieb schalten
Press twice
switches the whirl system to interval
operation (2-second rhythm)
Press 3 times switches off the whirl system
Air valve
Turn the air valve integrated on the edge of tub to adjust
the intensity of the added air. The air addition is based
on the Venturi principle. Only water will be circulated if
the air valve is fully closed.
04 English
43
Publicité
Table des Matières
