Publicité
Les langues disponibles
Les langues disponibles
English
4.5" (115 mm) and 6" (150 mm) grinding Wheels
Type 27 guard*
unthreaded backing flange
Type 27
depressed center wheel
threaded locking flange
* nOTE: A Type 27 guard is available at extra cost from your local dealer or authorized service center.
** nOTE: A conventional Type 1 guard is available at extra cost from your local dealer or authorized service center.
4.5" (115 mm) and 6" (150 mm) Cutting Wheels
Type 1/41 guard**
unthreaded backing flange
Type 27/42 depressed
center wheel, cutting only
threaded locking flange
Type 1/41 guards are intended for use with Type 1/41 cutting wheels and Type 27 wheels marked for cutting only.
Grinding with wheels other than Type 27 and Type 29 require different accessory guards. Always use the smallest proper
guard possible that does not contact the accessory.
14
ACCESSORIES CHART
Type 27 guard*
Type 27 hubbed wheel
4.5" (115 mm) and 6" (150 mm) sanding Flap Discs
Type 27 guard*
unthreaded backing flange
non-hubbed sanding flap disc
threaded locking flange
OR
Type 1/41 guard**
unthreaded backing flange
Type 1/41 abrasive cutting
wheel
threaded locking flange
Wire Wheels
Type 27 guard*
3 - 4" * (76.2 - 102 mm)
wire cup brush
Type 27 guard*
hubbed sanding flap disc
OR
Type 1/41 guard**
unthreaded backing flange
diamond cutting wheel
threaded locking flange
Type 27 guard*
4"-6" (100-150 mm) wire
wheel
sanding Discs
rubber backing pad
sanding disc
sanding clamp nut
Publicité
