Publicité
Les langues disponibles
Les langues disponibles
Fig. 5
000163
Fig. 6
000165
17. Never attempt to saw with the circular saw
held upside down in a vise. This is extremely
dangerous and can lead to serious accidents.
Fig. 7
000152
18. WARNING: Blade coasts to stop after switch is
released. Contact with coasting blade can
cause serious injury. Before setting the tool
down after completing a cut, be sure that the
lower (telescoping) guard has closed and the
blade has come to a complete stop.
19. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
hertz
･
alternating current
･
no load speed
･
Class II Construction
･
revolutions or reciprocation per minute
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting depth of cut
001338
CAUTION:
After adjusting the depth of cut, always tighten the
•
clamping screw securely.
Loosen the clamping screw on the depth guide and
move the base up or down. At the desired depth of cut,
secure the base by tightening the clamping screw.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for dangerous
6
USD201-2
1. Clamping screw
1
Publicité
