VOLTOMAT HEATING FH-109947.1 Mode D'emploi page 69

FH-109947.1
PARTS DESCRIPTION
1. Front cover
2. Front grille
3. Tip – over switch
4. Heat / ventilation select switch
5. Handle
6. Back cover
7. Thermostat control knob
Heat setting:
"0" position – OFF
" " – FAN
I WARM AIR (low heat output)
II WARM AIR (high heat output)
THERMOSTAT
1. Rotate the switch to choose the suitable setting ("
high heat output).
2. Turn the thermostat knob in a clockwise direction to the max position.
3. Once the room temperature has reached the desired value, turn the thermostat knob slowly in
anti-clockwise direction until you hear a "click" sound; this is the setting temperature.
4. The appliance will automatically maintain the setting temperature. It will switch on when the room
temperature is below the setting, and switch off if it is above the setting.
SAFETY SYSTEM
The appliance has a safety system which automatically switches off the unit when overheated.

If overheating occurs, switch off the appliance, remove the plug from the socket, and let it cool down

for at least 30 minutes. Put the plug in the socket and switch on the heater.
This heater is equipped with a tilt protection safety device. For safety reasons, the unit will

automatically switch off the power if it is put on unstable or uneven surfaces or if it is tilted
accidentally.
"= fan only, no heat/ "I"= low heat output/"II"=
- 68 -
GB