Displaying Stored Results - AEG BMG 5611 Mode D'emploi

7. DISPLAYING STORED RESULTS

a. After the measuring, you can review the measurements in the current memory
bank by pressing the button "MEM". Now the LCD displays the amount of the
results in the current bank. See Fig. 7.
Fig. 7
b. You can also press the "MEM" button in Clock Mode to display the stored
results. The current memory bank will flash and the amount of results in this
bank will be displayed. See Fig. 7-1. Press the "START" button to change to
the other bank. See Fig. 7-2. Confirm your selection by pressing the "MEM"
button. The current bank will also be confirmed automatically after 5 seconds
with no operation.
c. After selecting the memory bank, the LCD will display the average value of
the last three results in this bank. See Fig. 7-3 & 7-4. If no results are stored, the
LCD will show dashes as shown in Fig. 7-5.
Fig. 7-3
d. When the average is displayed and you press the "MEM" button, the most
recent result will be displayed. See Fig. 7-6. Then the blood pressure and the
pulse rate will be shown individually. Possibly the irregular heartbeat symbol
may flash. See Fig. 7-7 & 7-8. Press the "MEM" button again to display the
next result. See Fig. 7-9. In this way, repeatedly pressing the "MEM" button
displays the respective results measured previously.
Fig. 7-1
Fig. 7-4
Fig. 7-6
English
Fig. 7-2
Fig. 7-5
Fig. 7-7
89