Publicité
Les langues disponibles
Les langues disponibles
MAIN BROOM HEIGHT CHECK AND
ADJUSTMENT
1.
Check the main broom distance from the floor as shown
below:
•
Drive the machine on a level floor.
•
Keep the machine stationary and turn on the main
broom for a few seconds.
•
Turn off the main broom by pressing the switch (1),
then move the machine.
•
Check that the main broom print (A, Fig. 3), along its
length, is 3-5 cm wide.
•
If the print is not within specifications, adjust the broom
height as shown in step 2.
2.
Turn the main switch (1) to "0".
3.
On both sides of the machine, loosen the knob (A, Fig. 4).
4.
Grasp the support (B) on the points (C) and move it
upwards, then lift it or lower it to change the main broom
height. For height variation, refer to the indicator (D). Then
tighten the knob (A) on both sides of the machine.
5.
Perform step 1 again to check the proper adjustment of the
main broom height.
6.
When the broom is too worn to be adjusted, replace it as
shown in the next paragraph.
CAUTION!
If the main broom print is excessive (larger than
5 cm), the machine regular operation is affected
and the moving or electrical parts can overheat,
thus reducing machine life.
Pay careful attention when performing the above-
mentioned checks, and always use the machine
according to the indicated conditions.
146 3083 000(2)2008-11 A
USER MANUAL
Figure 3
C
D
B
C
Figure 4
FLOORTEC 350
ENGLISH
S311352
A
S311353
13
Publicité
Chapitres
Dépannage
