Publicité
Les langues disponibles
Les langues disponibles
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety
rules stated in this instruction manual
may cause serious personal injury.
SYMBOLS
The followings show the symbols used for tool.
V............................volts
A ...........................amperes
....................alternating or direct current
.....................no load speed
.....................Class II Construction
.../min....................revolutions or reciprocation per
minute
....................number of blow
FUNCTIONAL DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Switch action
1
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
USD294-2
003111
1. Switch trigger
Selecting the action mode
1
2
3
Rotation with hammering
For drilling in concrete, masonry, etc., rotate the change
lever to the
symbol.
Hammering only
For chipping, scaling or demolition operations, rotate the
change lever to the
CAUTION:
•
Do not rotate the change lever when the tool is run-
ning under load. The tool will be damaged.
•
To avoid rapid wear on the mode change mecha-
nism, be sure that the change lever is always posi-
tively located in one of the two action mode
positions.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Side handle
Raise the side handle. The side handle can be secured
in four position (right, left, up and down). To secure the
side handle, tighten the clamp nut securely. Never secure
the side handle in other than the above four positions.
1
2
4
003127
1. Change lever
2. For hammering
only
3. For rotation with
hammering
symbol.
003140
1. Clamp nut
2. Side handle
Publicité
