Wireless Output Module - Abus 2WAY Instructions D'installation

- Repeat this process exactly to train other detectors.
- After all detectors have been trained, exit the programming
mode by pressing ESC/DEL twice. Only the power supply
LED lights up/flashes and the fault LED lights up. The
accessory module beeps at short intervals.
Close both tamper contacts of the WAM and wait until it
emits a double tone.
3. If you want the wireless repeater to display the reception and
forwarding of wireless signals using the LED of the detector
channel, set dip switch 8 to ON. The LED of the respective
channel now lights up every time a signal is received from this
detector and forwarded.
4. The WAM can also be trained as a wireless repeater in the
wireless alarm system (optional). The advantage of this is that
a function error in the detector or wireless repeater
(battery/power failure, supervision failure or jamming) is
transmitted to the wireless alarm system. A maximum of eight
accessory modules can be trained as wireless repeaters in the
Secvest.
To train the wireless repeater in the wireless alarm system,
proceed as follows:
On the
Devices/Wireless Accessory Module" and follow the installation
instructions for the alarm system. When prompted, trigger the
tamper contact of the accessory module and wait until the
wireless alarm system receives the signal from the accessory
module.
Set dip switch 3 of the accessory module to ON.
6.3.2

Wireless output module

Function 2 / LED 2 (only in combination with the Secvest)
If the accessory module is used as a wireless output module, it
activates the four outputs (relay or transistor) when the
corresponding programming is made or a corresponding event
occurs. It is installed where a switch contact is required. The
accessory module can perform this function in combination with the
wireless alarm system, the remote control (FU5150/FU5155) or the
emergency call transmitter. Up to eight accessory modules can be
operated as wireless output modules with a wireless alarm system.
To use the accessory module as a wireless output module,
proceed as follows:
1. In the main programming menu, select item 7 (Function). LED
7 lights up.
Confirm by pressing SET.
In the function submenu, select function 2 with the SELECT
wireless alarm system, select
41
"Add Other