Keys; Dip Switches - Abus 2WAY Instructions D'installation

4.4

Keys

The keys are required for programming and navigation in the
programming menu. They have the following meanings:
SELECT: Press to start programming or to select another
function during programming.
SET: Press to confirm the selected function during
programming.
ESC/DEL: Press to end programming or to delete a selected
function during programming.
4.5

Dip switches

Some dip switches have different meanings depending on the
function of the accessory module. Some meanings are the same
for all functions. They have the following meanings:
1. OFF: The accessory module trains wireless transmitters via
infrared LED only.
ON: The accessory module trains wireless transmitters via
wireless protocol only.
2. OFF: The accessory module does not monitor jamming.
ON: The accessory module transmits a fault message in the
event of jamming. In function mode 6, relay 4 is activated
in the event of malfunctions.
3. OFF: The accessory module does not monitor the detectors
for supervision.
ON: The accessory module transmits a fault in case of a
supervision failure and sends a supervision message. In
function mode 6, relay 4 is activated in the event of a
supervision fault.
4. OFF: Short supervision time (20 minutes).
ON: Long supervision time (3 hours).
5. OFF: The inputs on the accessory module must be wired
without a resistor (NC).
ON: The inputs of the accessory module must be wired with a
2.2 kΩ resistor (EOL).
6. OFF: Input 1 of the accessory module works as an NC
contact.
ON: Input 1 of the accessory module works as an NO
contact.
7. OFF: Input 1 works as an input for key switches (imp).
35