Velleman 3DPEN2 Mode D'emploi page 7

9. Technical Specifications
input voltage ..............................5 V 2 A (USB cable)
power supply .. AC/DC adapter or power bank (not incl.)
screen ..........................................................OLED
pen material ................................................ plastic
nozzle ...................................... Ø 0.6 mm (ceramic)
printing material...........1.5-1.75 mm ABS/PLA filament
print range ...............................................unlimited
molding speed ........................................ adjustable
temperature ........................... 130-240 °C adjustable
dimensions.................................. 180 x 20 x 20 mm
pen net weight ................................................ 45 g
Use this device with original accessories only. Velleman nv
cannot be held responsible in the event of damage or injury
resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual,
please visit our website www.velleman.eu. The information in
this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied,
reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
V. 02 – 09/05/2016
3DPEN2
7 ©Velleman nv