Velleman 3DPEN2 Mode D'emploi page 5

4. Features
• can be driven by power bank, connection to AC/DC adapter not
needed
• double click loading/unloading button to fill and remove filament
automatically
• OLED screen, which can display company information,
temperature, speed and material
• OSD language: multi-language customized
• super slim design
5. Overview
Refer to the illustrations on page 2 of this manual.
1 power input
2
wire-feeding hole
3
OLED display
4
temperature
5
temperature
6. Operation
1. Insert the power plug from the adapter into the power input [1].
Connect the adapter to the mains. The OLED display [3] will
light; the pen is in standby mode.
2. Press the wire-feeding button [8] once. The OLED display [3]
will display the temperature to indicate the pen is preheating.
3.
Leave the pen to preheat for about 1 minute or until the OLED
display [3] displays the desired temperature.
4. Insert the filament through the wire-feeding hole [2] and hold
the wire-feeding button [8] pressed to load it into the pen. Wait
for molten filament to come out of the nozzle [9].
5.
The pen is now ready for use. Adjust the feeding speed with the
speed controller [7] if necessary.
6. When done drawing, hold the wire-unloading button [6] pressed
to unload the filament out of the pen. Next, hold the wire-
feeding button [8] pressed to extrude molten filament rests and
to clean the inside of the nozzle [9]. Disconnect the pen from
the mains and leave it to cool down before storing.
V. 02 – 09/05/2016
3DPEN2
6
7
8
9
5
wire-unloading button
speed controller
wire-feeding button
heating nozzle
©Velleman nv