Hkoenig ICEK12 Manuel D'utilisation page 6

DESCRIPTION:
1. Rear Cover
2.Top Cover
3. Water Tray
4. Evaporator
5. Ice Shovel
6. Ice-Bin-Full Sensor
7. Transparent lid
CONTROL PANEL OPERATION ：
The indicator of POWER will flash after plugged in, and then the machine enters standby state. It
will start to work by pressing POWER button, accompanying indicator lighting. During operation,
pressing this button, the machine will return to standby state.
This button is for selecting the size of ice. The default setting is large ice, if the small one is needed,
pressing this button is available. When you select the desired size, corresponding indicator of S
(small) or L (large) will be on.
Press and hold "SELECT" button for 3 seconds to activate pipeline self-clean process, which takes
"pump water in for 30 seconds---water tank run to drain out water" as a circle, and this circle will
run for 5 times. Flashing of indicators of "S" and "L" will take place in turn until self-clean process
is over and the machine enters standby mode. Take away the plastic plug to drain water and then
whole process is finished.
When the indicator of this button turns to red, it means insufficient water to water reservoir, you
need to add enough water and press POWER button to restart the machine.
8. Ice Basket
9. Water Reservoir
10. Filter
11. Water Drain Plug
12. Compressor
13. Power Cord
14. Control panel