Before Use; Refrigerator Use; Power On/Off Switch - Thermador KBUIT4250E Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Remove the Packaging
Remove tape and glue residue from surfaces before turning
on the refrigerator. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see "Refrigerator Safety."
Dispose of/recycle all packaging materials.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
4

BEFORE USE

Clean Before Using
After you remove all of the packaging materials, clean the inside of
your refrigerator before using it. See the cleaning instructions in
"Refrigerator Care."
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.

REFRIGERATOR USE

If you need to turn the power to your refrigerator On or Off, you
must remove the top grille to gain access to the On/Off switch.
Turn the power to the refrigerator Off when cleaning your
refrigerator or changing light bulbs.
Remove and Replace Top Grille
Remove Top Grille:
1. Grasp both ends of the top grille.
2. Push the top grille straight up, then pull straight out. Lay the
Replace Top Grille:
1. Insert top grille hooks (located on the back of the top grille)
2. Pull grille down slightly to lock into place.

Power On/Off Switch

top grille on a soft surface.
B
A. Top grille
B. Cabinet side trims
into the slots on the side trim.
A
B

Publicité

Table des Matières
loading

Table des Matières