Présentation de votre lave-vaisselle
Troubleshooting, what to do?
Poor operation
Possible causes
Traces of rust on stainless
- The quality of the stain-
steel
less steel (in knives in
particular) is unsuitable
for washing in a machine.
Poor washing results
Possible causes
A lot of drops on the
- Insufficient or no rinse
glasses
aid.
- The dose has not been
distributed.
- Position of the items.
Drops on plastic glasses,
- These insulating items
Tefal coatings, etc.
have a low calorific
mass.
Drying is less good in
- In the rapid pro-
rapid programmes.
grammes, the drying
temperature and the
drying time are reduced
to restrict the length of
the cycle to a minimum
level.
Condensation on the
- Condensation may form
walls of the inner door or
on the walls, particular-
the tub.
ly after cooling down
(sound insulation
increases its occurren-
ce).
52
What to do
- Use special "dishwa-
sher-safe" cutlery
- Check that the salt pot's
stopper is firmly closed.
What to do
- Check the indicator light
and fill the reservoir
completely.
- If the reservoir is not
empty after approxi-
mately 60 washes, call
an engineer.
- To relieve the problem,
arrange the items so as
to restrict as much as
possible any water
retention: if possible,
leave the door ajar for a
few minutes.
- Arrange them optimally,
prioritising the use of
the upper basket if pos-
sible.
- Select the most appro-
priate rapid programme.
GB
Instructions for laboratory tests
ENERGY EFFICIENCY TESTS ACCORDING TO AS/NZS 2007
PROGRAMME : "Bio" programme
Arrange items as shown in Figures A – B – C (see IEC load on
following page)
✔
Washing capacity
✔
Detergent dose
✔
Detergent dispenser
✔
Setting of upper basket
(no side shelves).
✔
The water softener MUST be set to
32) to deactivate the device. No salt is required.
✔
For more information on the comparison tests in
accordance with AS/NZS 2007, please contact the
manufacturer of the machine before commencing
testing.
GB
12 IEC
standardised
place setting
30 g
of detergent
3
High position
(see page
53