Mounting The Handlebar; Adjusting Of The Folding Device - URBANGLIDE Ride 82L Notice Originale

Assembly
To assemble the handlebars of your scooter, follow these steps:
1. Slide the brake handle onto the left base of the handlebar.
2. Screw on and adjust the brake handle.
3. Screw on the left handle of the scooter
4. Screw on the right handle of the scooter
Screw adjustment

Mounting the handlebar

Adjusting of the folding device

Locking pin
1.When the space in the folding device is too large,
the upper screw can be turned to the right with an
Allen key and the left and right screws must be
adjusted.
2.Before adjustment, make sure that the scooter is
in the adjustment lock state and after adjustment,
that the folding switch is elastic and can be used
normally. The locking pin may normally fall down.
7