OHAUS SPx303 Manuel D'instruction page 21

SPJ
Parts Counting
Parts Counting is enabled only when PC is turned ON in the .U.N.I.T. menu. In parts
counting mode, there are two modes of parts counting, normal and enhanced. In
normal parts counting, the balance determines the quantity based on the average weight
of the parts in the original reference quanitity. In the enhanced mode, additional parts
can be added to the platform equal to or less than the original number. The additional
reference quantity produces a more accurate average part weight.
Standard Parts Counting
(Press and hold until PC is displayed)
Y
1
Y
1
Enhanced Parts Counting
(Add less than 50)
NOTE: The preceding procedure for enhanced counting can be repeated as many times
as necessary providing the quantity added is less than the original entry.
(Place 50 parts)
(Clear average part weight)
(Press repeatedly to
N
change to 10, 20 or 50)
(Add parts to be counted)
or
(Add parts to be counted)
EN-17