Getting Started - XciteRC Rocket 65XS 3D Mode D'emploi

Getting started

• Connect the USB cable to a PC or appropriate power supply. The red LED lits.
• Connect the Quadrocopter battery with the charger.
• WARNING: The Quadrocopter battery is polarized. Check the side channels. Do not use force - fire
or explosion hazard!
• The red LED goes out to indicate charging. Charging time is about 60-70 minutes. If the battery is fully
charged, the red LED lights up again.
• Unplug the battery and the USB cable.
The flight time of the Quadrocopter is about 6-8 minutes.
Getting started
Before you begin please check:
• WARNING: Only start with a sufficiently full transmitter batteries (rechargeable batteries) and fully
charged drive battery – crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the flying qualities.
Insert battery
• Then switch on the transmitter. The POWER LED flashes.
• Connect the battery to the Quadrocopter, the blue LED's starts flashing.
• WARNING: The battery connector is polarized. Check the side channels. Do not use force - fire or
explosion hazard!
• Place the Quadrocopter in the starting position and move the left throttle lever all the way up and then
back in the lowest position. This safety circuit prevents the rotor may start after turning ON the Quadro-
copter
• The model is ready to fly as soon as the „DI-DA-DO" melody is heard. The POWER LED of the transmitter
lights up solid red, the blue LED's of the model stops flashing and lights up solid.
• Check the motor and servo functions.
• If the flight battery runs low, the motor speed is reduced and the Quadrocopter sinks automatically. Find
a suitable place to land safely. Charge the flight battery again.
XciteRC Rocket 65XS
PC
Insert the
battery in
the tray
Connect battery
EN
17