AEG RDB72321AX Mode D'emploi page 26

26 www.aeg.com
Problem
There is too much con-
densed water on the rear
wall of the refrigerator.
Door does not open easily.
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.
7.2 Replacing the lamp
The appliance is equipped
with a longlife LED interior
light.
CAUTION!
Disconnect the plug from
the mains socket.
1. Remove the screw from the lamp
cover.
2. Remove the lamp cover (refer to the
illustration).
Possible cause
There is no cold air circula-
tion in the appliance.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrap-
ped.
You attempted to re-open
the door immediately after
closing.
3. Replace the used lamp with a new
lamp of the same power and shape,
specifically designed for household
appliances. The maximum power is
shown on the lamp cover.
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains
socket.
7. Open the door.
Make sure that the light comes on.
7.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Solution
Make sure that there is cold
air circulation in the appli-
ance.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack-
aging before storing it in the
appliance.
Wait a few seconds between
closing and re-opening of
the door.