Publicité
Les langues disponibles
Les langues disponibles
Connection
Ignition key
switch
Car fuse box
Car fuse box
(Main fuse)
C
Battery
⁄
Connect to the vehicle's parking brake
detection switch harness.
Parking sensor wire (Light Green)
Connect to vehicle's reverse lamp harness when
⁄
To use the steering wheel remote control feature, you need to
an exclusive remote adapter (not supplied) matches your car is
required. When this terminal is not in use, leave its cap on.
Connect to the terminal that is grounded when either
⁄
connect either to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type antenna.
|
4
DNX7140/DNX7000EX/DDX714/DDX7034BT
¤
If you connect the ignition wire (red) and the battery
wire (yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire. Always
connect those wires to the power source running
through the fuse box.
ACC
A
B
A
B
C
PRK SW
For the sake of safety, be sure to connect the parking sensor.
using the optional rear view camera.
To steering remote
To car light control switch
the telephone rings or during conversation.
To connect the Kenwood navigation system,
consult your navigation manual.
Depending on what antenna you are using,
When using the optional power amplifier,
connect to its power control terminal.
⁄
If no connections are made, do not let the cable come out from the tab.
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) -
(To car chassis)
Reverse sensor wire (Purple/White)
Steering remote control input (Light Blue/Yellow)
Dimmer control wire (Orange/White)
Mute wire (Brown)
Motor antenna control wire (Blue)
Power control wire (Blue/White)
FM/AM
Antenna Cord
antenna input
Publicité
