Sony BRAVIA XBR-75X910C Manuel De Référence page 5

2
Remove the screws from the rear of the TV.
3
Secure the TV to the Stand.
Use the optional hardware listed as follows (not
supplied):
• M6 eye bolt (screwed into the TV's rear cover)
• A screw or similar (attach it to the Stand)
• Rope or chain (strong enough to support the weight of
the TV). Make sure that there is no excess slack in the
rope or chain.
Screw hole on the rear cover
Rope or chain (not supplied)
Screw (not supplied)
The length of the M6 eye bolt differs depending on the
rope or chain diameter. Please see below illustration.
8-12 mm
18 mm or more
M6 eye bolt
(not supplied)
4
Anchor the TV to the wall by using bolts, wall anchor and
chain (or rope).
M6 eye bolts (not supplied)
Screw holes
Please see below illustration for M6 eye bolt length.
8-12 mm
18 mm or more
Use the rope or chain for attaching the Table-Top Stand to
middle position, see page 14-15.
Note
• Your TV is shipped with screws attached to the rear of the
TV depending on the TV model. (They are fastened in the
screw holes for wall mounting.) Be sure to remove the
upper two screws prior to anchoring the TV to a wall.
• Securing the TV to the stand without securing the TV and
the stand to the wall provides minimum protection
against the TV toppling over. For further protection, be
sure to follow the three measures recommended.
Rope or
chain (not
supplied)
US
Wall-anchor
(not supplied)
4-5 mm
M5
5
US