Operation - Carrera 421 Mode D'emploi

06. OPERATION

WARNING! Risk of injury! Do not operate the shaver if the
shaving foil is damaged.
Regardless of the state of charge of the batteries, mains operation of
the appliance is always possible using the provided mains adapter only.
1. For mains operation connect the USB plug 11 to the USB female
connector 10 and the 5V plug 12 to the appliance.
2. Connect the mains adapter to an easily accessible wall socket.
3. Use the on/off switch 6 to switch on the appliance.
4. Press the on/off switch 6 to switch off the appliance
Dry shaving
NOTE:
Initial applications may result in a temporary redness or irritation of
● ●
the skin, since the skin must first get used to this type of shaving.
This is normal and usually takes between 2 and 4 weeks.
1. Remove the protective cap 1 from the shaving head.
2. Use the on/off switch 6 to switch on the shaver.
3. Hold the shaver at a right angle to the surface of the skin and move
it carefully and in circular motion over your face.
4. At parts of the face that are harder to shave, such as the chin, stretch
the skin to achieve a better result.
5. Shave against the direction of beard growth.
6. After shaving, switch off the shaver and clean the cutting elements
→●
carefully. ( 07. CLEANING AND CARE).
32 GB
Wet shaving
The appliance is also suitable for wet shaving (Wet & Dry).
● ●
ATTENTION!
The shaver is not waterproof. For wet shaves, the
device must be used in cordless mode. Never use the shaver in the
shower or in the bathtub.
Long haircut
Use the long hair trimmer 17 on the rear of the shaver to shorten
beard and sideburns.
1. Remove the protective cap.
2. Use the slide switch 18 to push up the long hair trimmer 17 .
3. Use the on/off switch 6 to switch on the shaver.
4. After use, switch off and clean the appliance.(→ 07. CLEANING AND
CARE). Push the long hair trimmer back to its original position.
Using the travel lock
This function prevents the shaver from being accidentally switched on
when travelling.
In order to activate the travel lock, press and hold the on/off switch
for 5 seconds. The shaver is switched off now and the padlock symbol
flashes several times. When pressing the on/off switch briefly, the
padlock symbol will flash and the shaver remains switched off.
In order to deactivate the travel lock, press and hold the on/off switch
for 5 seconds again. The shaver is being switched on and the charging
capacity display lights up in cordless operation.
If the shaver is connected to the mains for charging while the travel
lock is activated, the travel lock will be deactivated.
GB 33