AGA marvel MA15CRC Instructions D'installation, D'utilisation Et D'entretien page 17

Before You Call for Service
If the unit appears to be malfunctioning, read through this
manual first. If the problem persists, check the trouble-
shooting guide below. Locate the problem in the guide and
refer to the cause and its remedy before calling for service.
The problem may be something very simple that can be
solved without a service call. However, it may be required
to contact your dealer or a qualified service technician.
Problem
Unit operates but does not produce
any ice
Small ice cubes
Ice cubes are sticking together.
TROUBLESHOOTING YOUR ICE MACHINE
Possible Cause
• The unit has just been started and
it has been less than 24 hours.
• Water supply is not turned on.
• Inadequate water pressure to unit.
• The ice maker shut off arm is in
the uppermost position.
• Freezer section has not reached
temperature.
• Thermostat control set too warm.
• Condenser fan air flow is restrict-
ed.
• Room and/or water temperature is
too warm.
• Water input may require adjust-
ment.
• Ice consumption is low.
• Room temperature is too warm.
!
Electrocution Hazard
• Never attempt to repair or perform maintenance
on the unit until the main electrical power has been
disconnected. Turning the unit control "OFF" does
not remove electrical power from the units wiring.
• Replace all parts and panels before operating.
•
•
•
•
•
•
•
•
•
•
•
17
WARNING
Remedy
Typical ice production is up to
7 pounds per day. Allow for the
freezer section to reach tempera-
ture and the ice maker to cycle
and accumulate ice.
Turn on water supply to the unit.
Water pressure to the unit must be
at a minimum of 20 psi.
When the ice maker shut off arm
is in the uppermost position, the
ice maker is off. Flip the shut off
arm down to turn on the ice maker.
Allow the freezer section to reach
temperature.
Turn the temperature control to a
higher number to allow the unit to
run colder. Allow 24 hours be-
fore readjusting the temperature
control.
Make certain the grille in front of
the unit is free and open for air cir-
culation. Clean grille as required.
Move the unit to an area where
ambient temperature is below
90°F. The unit should not be
placed next to a heat source such
as an oven. Check for cold water
connection.
Due to differing water pressures,
the ice maker water input may
require adjustment. Contact a
qualified service technician if ad-
justment is needed.
Use the ice in the bin frequently.
Ice will stick together if left in insu-
lated bin over long periods of time.
Move the unit to an area that is
below 90°F.