Télécharger Imprimer la page

Danby Designer DUF167A4WDD Manuel Du Propriétaire page 4

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION INSTRUCTIONS
LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example in a wet basement or near a sink.
• This appliance is intended for indoor household
and garage use only. Freezers are tested to
perform in temperatures ranging from 0°F to
110°F (-17°C to 43°C). It is not designed for
outside installation, including anywhere that
is not temperature controlled such as porches,
vehicles, etc.
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is 76.1 cm (29.9 inches) wide by
170.9 cm (67.3 inches) high by 72.4 cm (28.5
inches) deep.
• Allow 12.7 cm (5 inches) of space between the
back, sides and top of the appliance and all
adjacent walls.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
OPERATING INSTRUCTIONS
FEATURES
1. Light Switch
2. Control Panel
3. LED Light
4. Airfl ow Outlet
5. Temperature Sensor
6. Freezer Shelf
7. Airfl ow Inlet
8. Shelf Front
9. Door Shelf
10. Adjustable Feet
2
3
4
5
6
7
8
10
LEVELING INSTRUCTIONS
There are two adjustable legs on the bottom of the
appliance that can be turned up or down to ensure
that the appliance is level.
1. Turn the leveling leg counter-clockwise as far as
it will go, until the top of the foot is touching the
bottom of the chassis.
2. Slowly turn the leveling leg clockwise until the
appliance is level.
3
1
9

Publicité

loading

Ce manuel est également adapté pour:

Designer duf167a4bsldd