Technical Data; Safety Instructions - WOLFF JIVE Traduction Du Mode D'emploi Original

Comes with:
Grinding machine JIVE
Tool kit
Operation manual
Check the power cord and the plug before starting. Both
of them must be in perfect condition, the insulation
must not be damaged.
Use this machine only
as instructed in this operating manual
with the machine in perfect working order.
01/2010

1.0 Technical data

Power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .230V 50 Hz
Power consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . .2200 W
No-load speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .230 rpm
Sound pressure level . . . . . . . . . . . . . . . . . . . . . . . . . .56 dB(A)
Sound energy level . . . . . . . . . . . . . . . . . . . . . . . . . . .67 dB(A)
Hand/Arm-Vibration . . . . . . . . . . . . . . . . . . . . . . . . . .< 4,5 m/s
Weight without supplies . . . . . . . . . . . . . . . . . . . . . . . . . .44 kg
Diameter of discs . . . . . . . . . . . . . . . . . . . . . . . . . . . . .375 mm
2.0
We declare under our sole responsibility that this product is in con-
formity with the following standards of standardization documents:
DIN EN 1037, EN ISO 12100, DIN EN 60204-1, DIN EN 60745-1,
DIN EN 55014-1, DIN EN 55014-2
according to the provisions of the: 2006/42/EC, 2004/108/EC,
2006/95/EC.
WOLFF GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde 1

3.0 Safety instructions

Disconnect the power supply before any maintenance is carried out.
Use only recommended mounting discs and brushes. The
mounting discs must have a plain surface.
Use only genuine Wolff discs and brushes. Other parts could
affect the safety of the machine. Maintenance should be under-
taken only by qualified personnel. Use only genuine Wolff spare
parts. Use only appropriate detergent liquids.
Have damaged insulation repaired at once, before starting the
machine. Otherwise this may result in considerable danger to
the user. See supplementary sheet "General safety instructions"
3.1 Introduction
This operating manual should be used to get the most benefit
from
instructions will both extend the life of your machine and reduce
repair costs.
Please ensure any user of the machine is fully familiar with the
instructions for use before allowing work to start.
3.2 Danger while working with the machine
The Grinding machine JIVE is designed to the highest technical
standards. Incorrect use can be dangerous! Disturbances that
could impair safety, have to be eliminated at once.
Einscheibenschleifmaschine JIVE, #056363
Declaration of Conformity
Dipl.-Ing. (FH) Dieter Hammel
Authorised to issue this declaration and for the
gathering of the technical documentation.
09.04.2015 i.V.
your Grinding machine JIVE. Following these
2
12