Publicité
Les langues disponibles
Les langues disponibles
DE GB NL FR
Blue = cold water entry side (for filling)
Red = hot water exit side (hot water demand)
This system allows water to be drawn from a single discharge point. Never use a
shut-off valve in the appliance's outlet.
The connection pipes must be installed as shown in the drawing.
Connection to the electricity supply
The device must be filled with water (see above). Only then
may the appliance be connected to the electricity supply (insert
the plug in the wall socket).
Connection of the device to the power supply network must
take place in accordance with electric installation standards and
as specified by local laws and regulations.
Avoid danger from damaged power supply cables. In the event of damage, the
device must be replaced by the manufacturer or its customer service department,
or by an equivalently-qualified person.
Internal modifications to the product may cause problems if
this work is not carried out by authorized and qualified tech-
nical staff. The warranty only applies if the product has not
been modified in any way, i.e. subject to it being in unchanged
condition.
3.5 kW: The device must be directly connected to the power supply network
(230V) via original electrical cable and plug.
4.5 / 5.5 kW: Observe the appliance name plate. The device must be directly con-
nected to the power supply network (230V). Loosen the two screws and then
remove the cover. Route the wiring through the cable entry and connect the cable
to the terminal block.
17
Publicité
