Danby DPA060BACBDB Guide D'utilisation Et D'entretien page 15

Installation Instructions
WATER DRAINAGE
When the internal drain pan becomes full the unit will beep 8 times
and the digital display will show error code P1. The air condition-
ing or dehumidifying action will stop but the fan may continue to
operate.
Turn the unit off and unplug it from the power source. Carefully
move the unit to a location where the water can be drained. Re-
move the bottom drain plug and allow the water to completely
drain. Replace the bottom drain plug, pressing fi rmly to ensure a
tight fi t and no leaks. The P1 error symbol will disappear and the
unit will resume regular function once power is restored.
If the P1 error persists when the unit has been drained of water,
turn the unit off and unplug it from the power source for at least
5 minutes. If the P1 error persists after plugging the unit back in,
please call Danby consumer care for further toubleshooting op-
tions.
During the DRY mode, you may wish to set up the continuous drain option so that the unit will auto-
matically drain collected water.
Remove the exhaust hose during DRY mode, it is not necessary. Ensure that the unit is turned off and
unplugged from the power source before setting up the drain hose.
Remove the upper drain plug and attach a 3/4" drain hose. Ensure that there are no kinks or bends in
the drain hose as this can stop water from draining.
Place the open end of the drain hose over the receptacle that the unit will drain into; this could be a
basement fl oor drain, a sink or similar.
Remember that there is no drain pump in this unit, the continuous drain is activated by gravity only.
Ensure that the drain hose goes straight down toward the fl oor from the drain connection. If the hose
is not positioned directly downwards, water will not drain correctly.
12