Multiplex Cockpit SX 7 Mode D'emploi page 32

7. Creating a model
9. Use the arrow
What is a mixer?
When we say mixer, we mean when not just the basic function
(e.g. elevation) but also additional controls (e.g. throttle) can
control the servo. Example: Your model gains altitude on its
own accord when the throttle is increased. This can be com-
pensated by mixing the throttle in the elevator. The elevator
is therefore controlled by the THROTTLE and the ELEVATOR.
· Mixing in the elevator

Undesired climb/descent when operating throttle, spoilers or
flaps can be compensated for. Elevation is the main input
and is controlled by the ELEVATION stick. The other three
inputs are mixed and controlled by the THROTTLE, SPOIL-
ERS and FLAPS. The result of the mix goes to the elevator.
- Select flaps, spoilers or throttle
- Set the desired values using the – and + buttons or
- Tap on the middle of the value to open the character and
number field. The current value can be deleted and a new
one entered.
· Mixing the aileron
The aileron mix is done in the same way. Here, there are
five options:
- Aileron (aileron mix - for aileron differential)
- Elevator (aileron mix - snap flap) mixing the aileron with
harder settings acting as a braking function
- Flaps (aileron mix - flaperon) use aileron as "flaps", with
the possibility of extending them upwards
- Spoilers (aileron mix - half butterfly) mixing the ailerons
with the flaps
- Offset (aileron offset) the current mixer values are shown
in the display.
Hint: You will find more details on the various mixer functions
in the section entitled "Example: 4-flap glider".
32
to go to the next menu "Mixer". 10. Use the arrow to go to the next menu "Control
settings".
- Select the relevant servo/function in the top field. Inside
the next three fields, you can set the dual rate and expo-
nential values.
- Tap on the middle of the value to open the character and
number field. The current value can be deleted and a new
one entered.
The current setting is shown on the graphic display.
Finally, press "Save", and the menu switches to the timer
menu and you have successfully programmed your first model.
Hint: You will find more details on the various transmitter con-
trol settings in the section entitled "Example: 4-flap glider".
Note on using the flight phases:
When flight phases are active it is possible - and necessary -
to set up and adjust all mixers and transmitter controls sep-
arately for each flight phase. Select each one of the flight
phases in turn using the flight phase switch "PHASE", and set
the values appropriately.
Please refer to the section entitled "Keypad".
Example: If you have programmed aileron in the flaps upon
starting or during normal flight, you need to then also enter
these values for the landing flight phases as well.
Please note: Cancel or back
If you select the wrong model by mistake or have made a mis-
take when entering the settings, you can cancel the program-
ming at any time or, using the left arrow key, go back to the
previous menu and correct your entries.