Whirlpool Cabrio Platinum WED8500 Guide D'utilisation page 7

Cycle Guide – Manual Cycles
Settings and options shown in bold are default settings for that cycle. Not all features and cycles are available on all models.
Not all settings and options are available on each cycle. Default cycle times are estimated in minutes.
Adjusting drying time on Timed Dry Cycles
When you select a Timed Dry Cycle,
the default time appears in the display.
Use the Time Adjust buttons to increase
or decrease the time in 1 minute
increments. Press and hold to change
the time in 5 minute increments.
The maximum dry time is 90 minutes.
Items to dry: Cycle:
Small loads and Quick Dry
sportswear
Any load Timed Dry
NOTE: Select Air
Only to dry foam,
rubber, plastic, or
heat-sensitive fabrics
Small to medium Touch Up (for
loads non-steam
models)
† Or Wrinkle Shield ™ with Steam (on some models). Wrinkle Shield
settings.
Cycle Guide – Steam Cycles
Settings and options shown in bold are default settings for that cycle. Not all settings and options are available on each cycle.
Steam cycles are designed for use with dry loads to loosen wrinkles, reduce odors, and refresh fabrics.
Items to refresh:
Mixed Loads Enhanced Touch
Shirts, blouses, and Quick Refresh (on
slacks some models)
Or Wrinkle Shield with Steam (on some models). Wrinkle Shield
† ™
settings.
Load Size Recommendations
For best results, follow the wet load size recommendations noted
for each cycle.
Small load: Fill the dryer drum with 3-4 items,
not more than 1/4 full.
Temp: Default
Time:
High
Medium
Low
Extra Low
Air Only
High
Medium
Low
Extra Low
Air Only
Cycle: Temp:
High
Up Medium
High
Selecting the Temp
A High heat setting may be used for drying heavyweight
items such as towels and work clothes.
A Low to Medium heat setting may be used for drying
medium-weight items such as sheets, blouses, dresses,
underwear, permanent press fabrics, and some knits.
Use a no-heat (Air Only) setting for foam, rubber, plastic,
or heat-sensitive fabrics.
Line dry bonded or laminated fabrics.
NOTE: If you have questions about drying temperatures
for various loads, refer to the care label directions.
Available
Options:
13 For small loads of 3-4 items
40 Wrinkle Use to dry items to a damp level for items that do not require
Shield an entire drying cycle. Select a drying temperature based
†
on the type of fabrics in your load. If you are unsure of the
temperature to select for a load, select the lower setting rather
than the higher setting.
20 Use this setting to help smooth out wrinkles from such items as
garments packed in a suitcase or garments wrinkled from being
left in the dryer.
™ with Steam is available only with High and Medium Temp
Default Available
Time: Options:
22
Wrinkle Prevent
Reduce Static
12
with Steam is available only with High and Medium Temp
™
Medium load: Fill the dryer drum up to about 1/2 full.
Large load: Fill the dryer drum up to about 3/4 full.
Do not overload. Items need to tumble freely.
Cycle Details:
Cycle Details:
Extended high-heat drying cycle intended to
help sanitize items such as bedding, towels,
and baby wear. This cycle is not recommended
for all fabrics. For best results, run cycle to
†
completion, do not interrupt.
Offers stepped drying starting with High heat,
followed by Medium heat for enhanced fabric
care and energy savings.
7