Tips For Saving Energytips For Saving Energy - Atlantic ATLKS84W10A+ Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT NOTES:
• W hile power cut, to prevent any compressor problem you should plug out the
refrigerator. You should delay plugging in 5 – 10 minutes after you power supply. If
you plug out the refrigerator for a reason you should wait at least 5 min to replug. It is
important for avoiding damage to refrigerator's components.
• The cooling unit of your refrigerator is hidden in the rear wall. Therefore, water droplets
or icing may occur on the rear surface of your fridge due to the operation of the
compressor in specified intervals. This is normal. There is no need to perform a
defrosting operation unless the icing is excessive.
• If you will not use your fridge for a long time (e.g. in summer holidays), put the
thermostat to "•" position. After defrosting, clean your fridge and leave the door open
to prevent humidity and smell.
• If the problem persists after you have followed all the instructions above, please
consult to the nearest Authorised Service.
• The appliance you have purchased is designed for home type use and can be used
only at home and for the stated purposes. It is not suitable for commercial or common
use. If the consumer use the appliance in a way that does not comply with these
features, we emphasise that the producer and the dealer shall not be responsible
for any repair and failure within the guarantee period.

Tips for saving energyTips for saving energy

1– Install the appliance in a cool, well ventilated room , but not in direct sunlight and
not near heat source (radiator, cooker.. etc). Otherwise use an insulating plate.
2– Allow warm food and drinks to cool down outside the appliance.
3– W hen thawing frozen food, place it in the refrigerator compartment. The low
temperature of the frozen food will help to cool the refrigerator compartment
when it is thawing. So it reduces the energy requirements.
4– W hen placing, drinks and liquids they must be covered. Otherwise humidity
increases at the appliance. Therefore the working time gets longer. Also covering
drinks and liquids helps preserve the smell and taste.
5– W hen placing food and drinks, open the appliance door as briefly as possible.
6– Keep the covers closed of any different temperature compartment in the appliance
(crisper, chiller ...etc ).
7– Door gasket must be clean and pliable. Replace gaskets if worn.
EN - 27 -

Publicité

Table des Matières
loading

Table des Matières