Terminal Assignment; Inputs And Outputs; Voltage Supply Connection; Wiring Examples - Baumer PA210 Guide Utilisateur

3 Connection
This chapter is about terminal assignment and will present some

wiring examples.

3.1 Terminal assignment

Litz contact only by means of connector sleeves with insulating
enclosures for reasons of shock protection according to EN 61010.
Do not otherwise assign contacts that have been left unassigned ex
factory. We recommend to screen all sensor terminal leads and to
ground the shield on one side. Shields on both sides are recommen-
ded in case of RF interference or in case of equipotential bonding
over long distances. The sensor leads should not be in the same
phase winding as the mains supply and the output contact leads.

3.2 Inputs and outputs

Signal
4...20 mA

3.3 Voltage supply connection

Device supply is via 4...20 mA current loop.
3.4 Wiring examples
www.baumer.com
Resolution Input resistance
0.01 mA 10
PA210
15