Electrical Connection; Start-Up Of The Cabinet - Tefcold BK850 Manuel Technique

Loosen the top hinge in the new hinge side and replace the door on the bottom hinge. The hinge is
pressed downwards on the door spring and is fastened. Put in the lock screw see fig. 1.6, close and
fasten the top with screws, see fig. 1.7.
Fig. 1.6 Fig. 1.7
Electrical connecting
The cabinet operates on 230 V/50 Hz.
The wall socket should be easily accessible.
All earthing requirements stipulated by the local electricity authorities must be observed. The
cabinet plug and wall socket should then give correct earthing. If in doubt, contact your local
supplier or authorized electrician.
The flexible cord fitted to this appliance has three cores for use with a 3-pin 13-Amp or 3-pin 15-
Amp plug. If a B.S. 1363 (13-Amp) fused plug is used, it should be fitted with a 13-Amp fuse.
The wires in this mains lead are coloured in accordance with the following code:
Green/Yellow: Earth, Blue: Neutral, Brown: Live.
The main electrical connections must be done by skilled electricians.

Start-up of the cabinet

Before use, we recommend that the cabinet is cleaned, see the section on maintenance and cleaning.
Important !
If the cabinet has been horizontally placed during transport, please wait 2 hours before starting up
the cabinet.
Remember to remove the transport safety device on the compressor. Remove the whole bar as
shown in fig. 1.8.
Fig. 1.8
19