Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Walls, ceiling
Combustible walls behind, next to, or above the fireplace must be shielded with at
least a 10 cm stone or brick w all and 10 cm insulation. Fireproof materials should be
covered with at least 6 cm insulation.
3.1.4. Combustible material round the fireplace
Within the radiation area of the fireplace
Assure a distance of at least 80 cm between the opening of the fireplace and com -
bustible material. That distance may be reduced to 40 cm if the combustible mate-
rial is sufficiently shielded and well ventilated.
Outside the radiation area of the fireplace
Assure a distance of at least 5 cm between the mantle built around the fireplace and
combustible material. A small surface contact between
combustible material and the mantle (e.g. wall cladding) is
allowed if the mantle of the fireplace is sufficiently insu-
lated.
A wooden ornamental rafter must not be installed within
the radiation area of the fire. Outside the radiation area,
there must always be a ventilation gap of 1 cm all around
to prevent heat from building up (see picture).
No combustible material must be present within 50 cm
from the convection outlet areas.
3.2.
Preparation
Please inspect the fireplace for damage caused during transport immediately after
delivery and notify your distributor in case there are any defects. Do not put the ap-
pliance into operation in the meantime.
In order to avoid damaging the fireplace during installation and to make its handling
easier, it is recommended to remove previously all loose parts (fire-resistant bricks,
grille, ashtray, ...) from the stove. Note the location of those parts while removing
them, so that you have no difficulties in re-assembling the parts later on.
3.2.1. Assembling the legs
See sketch.
3.2.2. Assembling the air-controls
See sketch.
3.2.3. Assembling of the door-closing
2000
36
min 1 cm
min 1 cm
03.27817.100
Publicité
Table des Matières
