ABAC CHISEL HAMMER Notice D'utilisation page 73

EN
Immediately shut down the equipment in case you hear unusual noises, or if a sudden power drop occurs. Check the
pneumatic tool and the compressed air supply system.
Pneumatic tool
- lubrication is insufficient
- worn tool/accessory, not suitable for use or faulted
Compressed air supply system
- compressor pressure is insufficient
- pressure regulator not set on the correct pressure level, suitable to the tool being used.
- there is a leak from the connection hose or from the connections (use Teflon tape or sealant paste)
- leaks in the pneumatic system
- filter or lubricator cogged
- hose is crushed, pierced or too long (loss of pressure)
Exhaust oil MUST BE DISPOSED OF so as not to pollute the environment and in compliance with the
applicable law.
Any warranty is expressly waved in case of damages arising out of regular wear, overload, handling or use not
suitable for the tool. For this warranty to be applicable, the tool should not be dismantled when returned to your
retailer.
This warranty covers replaced parts and labor for a period of 12 months from the date of purchase (a proof of
purchase such as invoice or receipt is required).
Any defect may be removed by replacing the tool or repairing it, as the case may be.
POSSIBLE FAULTS
DISPOSAL
73