Publicité
Les langues disponibles
Les langues disponibles
5
Maintenance and cleaning
Filter Cartridge / Door Inner Surface
Lint and fibres released from the laundry to the air
during the drying cycle are collected in the "Filter
Cartridge".
C
Such fibre and lint are generally formed
during wearing and washing.
C
Always clean the filter and the inner surfaces
of the cover after each drying process.
C
You can clean the filter and filter area by
vacuum cleaner.
To clean the filter:
1. Open the loading door.
2. Remove the cover filter by pulling it up and
open the filter.
3. Clean lint, fibre, and cotton raveling by hand
or with a soft piece of cloth.
4. Close the filter and place it back into its
seat.
C
Clogging may arise on the filter surface after
using your machine for some time; if this
occurs, wash the filter with water and dry it
before using again.
C
Clean the entire inner surface of the cover
and door gasket.
Water tank;
The moisture in the damp laundry is taken from
the laundry and condens ed. Drain the water
tank after each drying cycle or during drying
when "Water tank" warning light turns on.
A
Condensed water is not drinkable!
A
Never take out the water tank when the
programme is running!
If you forget to drain the water tank, your dryer
will stop during the following drying cycles
when the water tank is full and the "Water tank"
warning light will turn on. If this is the case, press
the "Start/Pause/Cancel" button to resume the
drying cycle after draining the water tank.
*To drain the water tank:
1-Carefully remove the water tank by opening
the kick plate cover/pulling the drawer.
32 EN
Publicité
