Kenwood KDC-X700 Mode D'emploi page 35

Wiring connection
IMPORTANT : We recommend installing the unit with a commercially available custom wiring harness specific for your car and leave this job to
professionals for your safety. Consult your car audio dealer.
When connecting to an external amplifier, connect its ground
wire to the car's chassis to avoid damaging the unit.
Antenna terminal
Rear/ front/ subwoofer output
To front speaker (left)
To front speaker (right)
To rear speaker (left)
To rear speaker (right)
Ignition switch
Car fuse box
Car fuse box
Black (Ground wire)
To the metallic body or chassis of the car
Battery
Fuse (10 A)
Expansion port (12 V
To the optional SiriusXM Vehicle Tuner
(commercially available) ( 12)
White
If no connections are made, do not let the wire come out from the tab.
White/Black
Gray
Brown
Gray/Black
(Mute control wire)
Green
Green/Black
Purple
Purple/Black
Blue/White
(Power control wire/
Antenna control wire)
Red
(Ignition wire)
Light blue/yellow
Yellow
(Battery wire) (Steering remote
control wire)
MIC (Microphone input terminal) ( 15)
500 mA)
To connect the Kenwood navigation
system, refer your navigations manual
To the power control terminal when using
the optional power amplifier or to the
antenna control terminal in the vehicle
To the steering wheel remote control
adapter
Part list for installation
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
31
ENGLISH